索引
A
AC Supply 交流
Source 电源 1-4
Unbalanced 不平衡 1-4
Ungrounded 不接地 1-4
AC Supply Source Consideration 交流电源注意事
项 1-4
Access 入口
Tap 抽头 1-11
Access Panel 入口板 1-10
Ambient Temperature 周围环境温度 1-3
Application Notes 应用注释 C-1
Armored Cable 铠装电缆 1-8
Assisted Start-Up 辅助起动 2-5
ATEX Application ATEX 应用 J-1
Drive Hardware Configuratio n 变频器硬件组
态 J-4
Drive W i ring 变频器接线 J-2
Motor Requirement 电动机需求 J-1
Auxiliary Power Supply 辅助电源 1-21,A-31
B
Before Applying Power 接通变频器电源之前 2-1
Bipolar Input s 双极性输入 1-19
Bottom Plate Removal 底板拆卸 1-9
Brake Resistor 制动电阻 1-15
C
Cable 电缆 1-9
Cable Entry Plate 电缆入口板
Removal 拆除 1-9
SHLD Terminal 屏蔽端子 1-6
Cable Length
Motor 电动机电缆长度 1-9
Cable Trays 电缆槽 1-9
Cables, Power 电源电缆
Armored 铠装 1-8
Insulation 绝缘 1-7
Separation 隔离 1-7
Shielded 屏蔽 1-7, 1-8
Type 类型 1-7
Unshielded 未屏蔽 1-7
Class 1 LED Product 一类LED产品 P-4
Clear
Faults Manually 手动清除故障 4-4
Clearances
Mounting 装备清单 1-3
Clearing Faults 清错 4-4
Command Word
Logic 逻辑命令字 A-5
Common Mode Capacitors
共模电容器 1-17
Common Mode Interference
共模干扰 1-19
Common Start-Up Faults 常见起动故障 2-5
Communication
Masks & Owners 通讯
屏蔽码&优先权 3-12
Communications
Programmable Controller Configurations可编程
控制器通讯组态 A-5
Compatible Motors
Thermistor 与电动机匹配的热敏电阻 A-30
Conduit 导线管 1-9
Conformity
CE CE一致性 1-29
Contactors
Input/Output 输入/输出接触器 1-16
Control Block Diagrams 控制模块图 B-1
Control Wi re 控制线 1-19
Controller
DriveLogix DriveLogix控制器 P-2
Conventions 规定 P-3
Cooling Fan Voltage 冷却风扇电压 1-10
Copycat 拷贝 D-4
Cover
Opening 机壳打开 1-2
Covers
Removing 机壳拆除 1-2
D
Data, Saving 数据,保存D-4
Defaults, Resetting to 缺省值,复位至 D-4
Diagnostic Data, Viewing 诊断数据,查看 D-4
Distribution Systems 供电系统 1-17
Unbalanced 不平衡 1-4
Ungrounded 不接地 1-4
Documentation 文档 P-1
DPI Communication Configurations DPI通讯组
态 A-5
评论